|Recent Ariane 6 concept. Credit: CNES|
While Ariane 5 has so far had little trouble keeping up with Proton, this has always required a significant amount of government subsidies. Currently, an Ariane 5 costs about €150 millions for 10 tons to a Geostationary Transfer Orbit, and receives on average €120 million in subsidies per year. For comparison, a Proton costs less than €80 million per launch with a payload of 6.5 tons. In addition to this, Ariane 5 launches two satellites at a time, one big one (in the range of 6 tons) and a small one, in the range of 3 tons. This means that any customer will have to wait until a suitable second customer is found for a launch, and as satellites are getting heavier, this is becoming more and more difficult. This can be seen in the design of many new vehicles; with the exception of the SpaceX Falcon Heavy, most commercial launch vehicles like Proton or GSLV have payloads to GTO in the range of 4 to 7 tons.
While Europe is currently developing Ariane 5 ME, which will reduce costs per kg to GTO by 20% and remove the need for subsidies, but even though the payload increase alleviates it somewhat the dual launch problem will remain. This is a problem the European Space Agency ESA has realized and the reason they decided on the development of a new launch vehicle, the Next Generation Launcher, recently dubbed Ariane 6. For the first time, Europe is designing a launcher with low cost in mind, with the goal of reducing the cost for both commercial, military and scientific payloads.
The current baseline design is a surprising design that has little similarity to previous concepts. It uses four common rocket stage carrying 135 tons (newer sources indicate 145 tons) of solid rocket propellant, with two or three of these "cores" making up the first stage and a single one making up the second stage. An upper stage would use a single cryogenic Vinci engine and use hydrogen and oxygen to propel the payload into the target orbit. The payload to GTO is 6.5 tons for the full configuration, and a version using two solids in the first stage would bring 3.4 tons to GTO (the two solid configuration was originally claimed by CNES but hasn't been mentioned for some time now). The goal is to cost only €70 million, or about $95 million dollars.
During a recent tweetup, the French Space agency CNES claimed that Ariane 6 could evolve to lift between 4 and 8 tons to GTO, with the 8 ton version using five solid boosters as a first stage. A 4 ton version might use two solids or three solids as first stage, as this wasn't specified. However, the vehicle would likely be evolvable, like SLS, rather than modular like the EELVs. A six-solid configuration would require modifications to the current design which would reduce performance on the current four solid configuration.
How the design came to beThe design of Ariane 6 is quite unusual, with no previous vehicle concepts looking anything like it. This is reflected in the way it was received, with reactions ranging from "brilliant" to "the end of European access to space". It might look like it was clumped together, but you can't be more wrong about that. It was a result of a long series of trade studies, and the advantages of the design are less obvious than you might think.
In 2012, ESA started the NELS study: New European Launch Service. This study evaluated over 700 launch vehicle concepts on several different factors including cost, payload, reliability, development cost and risk. The main concepts were:
- KH: Kerosene first stage with NK-33 engines.
- HH: Three Vulcain-3 engines on the first stage, no boosters.
- HH-PPB: Two Vulcain-3 engines, small P20 boosters.
- PPH: P340 first stage, P110 second stage.
- Multi-P: Solid common cores (the later selected design).
- PPH-PPB: P180 first stage, P110 second stage, P40 boosters
- KH-CCB/HH-CCB: Hydrogen or Kerosene first stage using common core boosters to reach the 6.5 ton requirement.
All of these concepts used a hydrogen upper stage with a single Vinci engine.
Out of these concepts, the PPH concept was the cheapest, especially at low flight rates. However, it had significant development risk because the P340 solid first stage would be the biggest and most powerful monolithic solid motor ever made by a very large margin.
Below that, KH, HH and Multi-P all had very similar cost, slightly higher than PPH. However, HH and KH were not configurable like Multi-P, meaning that they were more expensive and less flexible with smaller payloads. On top of that, KH required the use of Russian engines rather than European ones if the design was to make the 2020 first launch mandate, which made it a political dead end.
At the bottom where the strap-on and common core designs. While these vehicles were cheaper for small payloads in the 3.5 ton range, they proved to be slightly more expensive than the concepts above them. Strap-on boosters cause a large increase in fixed cost and common cores are a lot more expensive than simply stretching the core.
From this, the advantages of Multi-P become clear. The vehicle combines the low cost of an in-line concept with the versatility of the modular designs, with moderate development risk and a lower cost increase at low flight rates. On top of that, the common core also allows to function as the first stage of Vega, which would increase Vega's payload and reduce the cost of the small launcher.
Later, ESA further down selected Ariane 6 concepts. However, because both ESA and CNES usually have payloads in the smaller range, the modular concepts gained an upper hand again. Currently, European nations have to rely on the Russian Soyuz for these smaller payloads, and independence is an important requirement for Ariane 6. In fact, it is the main reason Ariane exists in the first place: Independent access to space for Europe. For these reasons, the eventual choice came down to three concepts: H2C, P1B and P7C, which were HH-PPB, PPH-PPB and Multi-P from the previous study, as these allowed for full independence at lower cost than any of the kerosene hydrogen CCB concepts.
With these concepts, the choice became a lot easier. P7C, or Multi-P, provided the synergies with Vega and a lower cost than the other designs, even if it was slightly less flexible. Combine this with Italy's and France's love for solid boosters, and the winner is clear.
|The final three Ariane 6 configurations. Credit: Aviation Week|
Can it compete?
Disclaimer: This part is slightly opinionated.
Whether Ariane 6 can compete with the other upcoming competitors will depend on a lot of different factors. The first one is whether they can reach the €70 million goal with 6.5 tons to GTO. This is a rather aggressive cost goal as this is 30% lower in cost per kilogram than the current Ariane 5. Most preliminary studies showed this to be difficult to reach, and in order to reach this, ESA has decided to throw the conventional development structure out of the window.
""Unlike past ESA development projects, Ariane 6 is being designed by industry to meet cost and technical requirements without regard for where the work is conducted. ESA’s contract pillar — geographic return guaranteeing governments that the money they spend at ESA will be returned in the form of contracts to their national industry — has been tossed aside for Ariane 6."
In an interview with lesechos, ESA director General Jean Jacques Dordain claimed that while it was going to be difficult, the cost goal was possible. Later, it was also announced that the supplier base was being cut by two-thirds. All of these things together mean that the €70 million cost goal is definitely not impossible, even if it might become hard to reach.
It will also depend on what the competition will be capable of doing. The most dangerous looking competitor at the moment seems to be SpaceX. They have already managed a significant reduction in cost, at least they advertise as such. These figures should be approached with slight skepticism, as Falcon 9 is not yet a mature system, but they are very low and they are already starting to capture a large customer base and full manifest.
|The SpaceX Falcon 9 is one of the biggest competitors Ariane might face. Credit: SpaceX|
However, Ariane 6 should be competitive with their current vehicles at a reasonable launch rate of 9 per year. While the claimed payload to GTO for Falcon 9, 4.85 tons, would imply a much lower cost per kg, it should be remembered that this Falcon 9 GTO requires the satellite to perform 1800 m/s of velocity change by itself, while the Ariane 6 GTO requires only 1500 m/s. The equivalent payload of Falcon 9 to the same orbit, which was also used by SES-8, is only about 3.5 metric tons. This results in a price per kg which is almost identical to Ariane 6.
But then there is another issue. SpaceX has set a goal of making Falcon 9 and Falcon Heavy fully reusable launch vehicles. And they have been making steady progress on this front. On the first flight of Falcon 9v1.1, with the launch of CASSIOPE, they successfully landed the Falcon 9 first stage in the ocean, with only a small roll problem causing the engine to shut down too early.
While full reusability is likely many years away, first stage reuse might be just around the corner, as an attempt to fly the first stage with legs is planned for early March. Reuse of the first stage will cause a large payload decrease however, of about 30%. For Falcon Heavy it is likely more as the first stage will separate much later than on Falcon 9, and for GTO, this is likely even more, as the upper stage will have to do even more work with the first stage's earlier separation. This means that it is possible the cost/kg reduction for GTO is not huge, or maybe non-existant.
|Falcon 9 first stage coming in for landing. Credit: SpaceX|
|PRIDE reusable demonstrator servicing a satellite. Credit: ESA|
|IXV reentry demonstrator reentering the atmosphere. Credit: ESA|
The option to replace the second and third stage of Ariane 6 with an IXV/PRIDE derived cryogenic upper stage is an attractive one and hopefully one ESA are looking into. Currently though, the Ariane 6 design appears to show little interest in partial reusability, which it definitely should.
Ariane 6 has the potential to be a very competitive launch vehicle and it's aggressive cost target, versatility and responsiveness make it a very welll-rounded option. However, as long as the threat of reusability looms around the corner, it should be payed attention to. The option of implementing reusability into Ariane 6 should be available, and the current design appears to keep little of this in mind. If this doesn't happen, it's very well possible Europe in 10 years might no longer be in the comfortable position it is in now.